Throttle Cable Adjustment - Yamaha TT-R50E Owner's Service Manual

ENGINE/THROTTLE CABLE ADJUSTMENT
2
b
1
c
EC350000
ENGINE

THROTTLE CABLE ADJUSTMENT

1. Check:
• Throttle grip free play a
Out of specification → Adjust.
Throttle grip free play a:
3 ~ 5 mm (0.12 ~ 0.20 in)
2. Adjust:
• Throttle grip free play
Throttle grip free play adjustment steps:
Carburetor side
NOTE:
Before adjusting the throttle cable free play,
the engine idle speed should be adjusted.
• Remove the seat assembly and air scoop
(right).
Refer to
ASSEMBLY AND FUEL TANK" section in
the CHAPTER 4.
• Pull back the adjuster cover.
• Loosen the locknut 1 on throttle cable.
• Turn the adjuster 2 in or out until the
specified free play is obtained.
Turning in b → Free play is increased.
Turning out c → Free play is decreased.
• Tighten the locknut.
• Slide the adjuster cover to its original posi-
tion.
• Install the seat assembly and air scoop
(right).
NOTE:
If the specified throttle cable free play can-
not be obtained on the carburetor side of the
cable, use the adjusting nut on the handle-
bar side.
WARNING
After adjusting, turn the handlebar to
right and left and make sure that the
engine idling does not run faster.
3 - 4
INSP
ADJ
"FRONT FENDER, SEAT