Yamaha TT-R50E Owner's Service Manual page 324

1
b
a
b
a
c
1
1
a
1
b
2
5 - 12
HANDLEBAR
3. Install:
• Engine stop switch 1
NOTE:
Align the tab a on the engine stop switch
holder with the hole b in the handlebar.
4. Install:
• Start switch 1
NOTE:
Align the mating surfaces a of the start switch
with the punch mark b on the handlebar.
5. Install:
• Throttle cable 1
NOTE:
After installing the throttle cable, insert the rub-
ber seal and throttle cable guide completely
into the hole in the start switch housing, mak-
ing sure that the rubber seal flange a, throttle
cable guide flange b, and housing c contact
each other.
6. Install:
• Screws (start switch) 1
WARNING
After tightening the screws, check that the
throttle grip 2 moves smoothly. If it does
not, retighten the screws for adjustment.
CHAS