Protocol Definition Parameters - 3Com VCX V7122 User Manual

Protocol Definition Parameters

Use this submenu to configure the following gateway's specific SIP protocol parameters:
General Parameters
Proxy & Registration Parameters
Coders (see Coders
DTMF & Dialing Parameters
Coders
From the Coders screen you can configure the first to fifth preferred coders (and their
corresponding ptimes) for the gateway. The first coder is the highest priority coder and is
used by the gateway whenever possible. If the far end gateway cannot use the coder
assigned as the first coder, the gateway attempts to use the next coder and so forth.
To configure the gateway's coders, follow these steps:
1
Open the 'Coders' screen (Protocol Management menu > Protocol Definition
submenu > Coders option); the 'Coders' screen is displayed.
Figure 18 Coders Screen
2
From the coder drop-down list, select the coder you want to use. For the full list of
available coders and their corresponding ptimes see the ini file parameter 'CoderName'
(described in Table 27
Note: Each coder can appear only once.
3
From the drop-down list to the right of the coder list, select the size of the Voice Packet
(ptime) used with this coder in milliseconds. Selecting the size of the packet determines
how many coder payloads are combined into one RTP (Real-Time Transport Protocol)
(voice) packet.
Note 1: The ptime packetization period depends on the selected coder name.
Note 2: If not specified, the ptime gets a default value.
Note 3: The ptime specifies the maximum packetization time the gateway can receive.
4
Repeat steps 2 and 3 for the second to fifth coders (optional).
5 Click the Submit button to save your changes.
6
To save the changes so they are available after a power fail see
page 88.
Only the ptime of the first coder in the defined coder list is declared in Invite/200
OK SDP, even if multiple coders are defined.
46
below)
on page 103).
3Com VCX V7122 SIP VoIP Gateway User Manual
Save Configuration on