Advanced Configuration; Configuring The Network Settings - 3Com VCX V7122 User Manual

Mode
Cyclic Descending
Descending
Number + Cyclic Ascending
The internal numbers of the gateway's B-channels are defined in the 'Trunk Group
Table' under the 'Phone Number' column. For detailed information on the 'Trunk
Group Table', refer see

Advanced Configuration

Use this subdivided menu to set the gateway's advanced configuration parameters (for
advanced users only).

Configuring the Network Settings

From the Network Settings page you can define:
IP settings.
NTP settings.
Syslog settings.
SNMP settings.
RTP settings.
Ethernet Ports Information (read-only).
To configure the Network Settings parameters, follow these steps:
1 Open the 'Network Settings' screen (Advanced Configuration menu > Network
Settings); the 'Network Settings' screen is displayed.
2
Configure the Network Settings parameters.
3
Click the Submit button to save your changes.
4 To save the changes so they are available after a power fail, see
page 88.
3Com VCX V7122 SIP VoIP Gateway User Manual
Description
Select the next available channel in descending cycle order.
Always select the next lower channel number in the Trunk Group.
When the gateway reaches the lowest channel number in the Trunk
Group, it selects the highest channel number in the Trunk Group
and then start descending again.
Select the highest available channel. Always start at the highest
channel number in the Trunk Group and if that channel is not
available, select the next lower channel.
First select the gateway port according to the called number (see
the note below). If the called number isn't found, then select the
next available channel in ascending cyclic order. Note that if the
called number is found, but the port associated with this number is
busy, the call is released.
Configuring the Trunk Group Table on page 62).
Save Configuration on
65