3Com VCX V7122 User Manual page 122

ini File Field Name
*
Web Parameter Name
RemovePrefix
[IP to Tel Remove Routing
Table Prefix]
RouteModeIP2Tel
[IP to Tel routing Mode]
RouteModeTel2IP
[Tel to IP routing Mode]
SwapRedirectNumber
[Swap Redirect and Called
Numbers]
AddTON2RPI
[Add Number Plan and Type
to Remote Party ID Header]
NumberMapTel2IP
[Destination Phone Number
Manipulation Table for
Tel IP calls]
122
Valid Range and Description
0 = Don't remove prefix (default).
1 = Remove PSTN prefix (defined in the routing table) from a telephone number of an
incoming IP call, before forwarding it to PSTN.
Applicable only if number manipulation is performed after call routing for IP Tel calls
(RouteModeIP2Tel = 0).
0 = Route calls before number manipulation (default).
1 = Route calls after number manipulation.
Defines order between routing calls to Trunk group and manipulation of destination
number.
0 = Route calls before number manipulation (default).
1 = Route calls after number manipulation.
Defines order between routing incoming calls to IP, using routing table, and
manipulation of destination number.
Not applicable if Outbound Proxy is used.
0 = Don't change numbers (default).
1 = Incoming ISDN call that includes redirect number (sometimes referred as "original
called number") uses this number instead of the called number.
0 = TON/PLAN parameters aren't included in the RPID header.
1 = TON/PLAN parameters are included in the RPID header (default).
If RPID header is enabled (EnableRPIHeader = 1) and 'AddTON2RPI=1', it is
possible to configure the calling and called number type and number plan using the
Number Manipulation tables for Tel IP calls.
Manipulates the destination number for Tel to IP calls.
NumberMapTel2IP = a,b,c,d,e,f,g
a = Destination number prefix
b = Number of stripped digits from the left, or (if brackets are used) from the
right. A combination of both options is allowed.
c = String to add as prefix, or (if brackets are used) as suffix. A combination of
both options is allowed.
d = Number of remaining digits from the right
e = Number Plan used in RPID header
f = Number Type used in RPID header
g = Source number prefix
The 'b' to 'f' manipulations rules are applied if the called and calling numbers match
the 'a' and 'g' conditions.
The manipulation rules are executed in the following order: 'b', 'd' and 'c'.
Parameters can be skipped by using the sign "$$", for example:
NumberMapTel2IP=01,2,972,$$,0,0,$$
NumberMapTel2IP=03,(2),667,$$,0,0,22
3Com VCX V7122 SIP VoIP Gateway User Manual