3Com VCX V7122 User Manual page 227

To start and collect the PSTN trace via the Web, please use the following instructions. (See
Figure 81 for a view of the Trunk Traces). Also, please note if the PSTN trace was of a PRI
or CAS collection based on the framer involved in the trace. This information is needed to
properly parse the captured data.
1
Run the UDP2File utility.
2
Determine the trace file name.
3 Determine the UDP port.
4
Mark the PSTN Trace check box.
5 Push the Run button=> the UDP2File utility starts to collect the trace messages.
6
Activate the Web page by entering <M2K IP address>/TrunkTraces, such as:
http://10.8.8.101/TrunkTraces. The user and password is the same for the unit.
7 In the Web page set the trace level of each trunk.
8 Enable the trace via the Web.
9
Determine the UDP port (the same as in step 3).
10 Push the Submit button => the board starts to send the trace messages.
In the UDP2File utility (see
increasing.
Figure 81
Trunk Traces
Figure 82 UDP2File Utility
3Com VCX V7122 SIP VoIP Gateway User Manual
Figure 82) you should see the number in the packets counter
227