Configuring The Bootp Clients; Adding Clients - 3Com VCX V7122 User Manual

Boot File Mask: Boot File Mask specifies the file extension used by the TFTP utility for
the boot file that is included in the BootReply message. This is the file that contains VoIP
gateway software and normally appears as cmp.
ini File Mask: ini File mask specifies the file extension used by the TFTP utility for the
configuration file that is included in the BootReply message. This is the file that contains
VoIP gateway configuration parameters and normally appears as ini.
Timeout: This specifies the number of seconds that the TFTP utility waits before
retransmitting TFTP messages. This can be left at the default value of 5 (the more
congested your network, the higher the value you should define in these fields).
Maximum Retransmissions: This specifies the number of times that the TFTP utility
tries to resend messages after timing out. This can be left at the default value of 10 (the
more congested your network, the higher the value you should define in these fields).

Configuring the BootP Clients

The Clients window, shown in
specific VoIP gateway.
Figure 68 Client Configuration Screen

Adding Clients

Adding a client creates an entry in the BootP Tool for a specific gateway.
3Com VCX V7122 SIP VoIP Gateway User Manual
Figure 68 below, is used to set up the parameters for each
199