3Com VCX V7122 User Manual page 184

<x> = a number 0, 1, 2 which is the array element index. Currently, up to 5 SNMP trap
managers can be supported.
Figure 64 presents an example of entries in a device ini file regarding SNMP. The device can
be configured to send to multiple trap destinations. The lines in the file below are commented
out with the ';' at the beginning of the line. All of the lines below are commented out since the
first line character is a semi-colon.
Figure 64 Example of Entries in a Device ini file Regarding SNMP
; SNMP trap destinations
; The board maintains a table of trap destinations containing 5 ;rows. The rows are
numbered 0..4. Each block of 4 items below ;apply to a row in the table.
; To configure one of the rows, uncomment all 4 lines in that ;block. Supply an IP
address and if necessary, change the port ;number.
; To delete a trap destination, set ISUSED to 0.
; -change these entries as needed
;SNMPManagerTableIP_0=
;SNMPManagerTrapPort_0=162
;SNMPManagerIsUsed_0=1
;SNMPManagerTrapSendingEnable_0=1
;
;SNMPManagerTableIP_1=
;SNMPManagerTrapPort_1=162
;SNMPManagerIsUsed_1=1
;SNMPManagerTrapSendingEnable_1=1
;
;SNMPManagerTableIP_2=
;SNMPManagerTrapPort_2=162
;SNMPManagerIsUsed_2=1
;SNMPManagerTrapSendingEnable_2=1
;
;SNMPManagerTableIP_3=
;SNMPManagerTrapPort_3=162
;SNMPManagerIsUsed_3=1
;SNMPManagerTrapSendingEnable_3=1
;
;SNMPManagerTableIP_4=
;SNMPManagerTrapPort_4=162
;SNMPManagerIsUsed_4=1
;SNMPManagerTrapSendingEnable_4=1
The same information configurable in the ini file can also be configured via the
acBoardMIB.
Configuration via SNMP
To configure trap destinations, the EM must use the snmpTargetMIB. Up to 5 trap
destinations can be configured.
To add a trap destination:
Add a row to the snmpTargetAddrTable with these values:
Name=trapN, TagList=AC_TRAP, Params=v2cparams, where N is an unused number
between 0 and 4.
184 3Com VCX V7122 SIP VoIP Gateway User Manual