Forced Idle Reminder Tones; Programming From The Console; System Programming Console - AT&T MERLIN LEGEND Release 3.1 System Manager's Manual

Programming from the Console

Table 6–4, Continued
Idle State Description
Line or Trunk The line or trunk is idle only at
the instant of programming .
Idle
100D Module Only the 100D module is
Idle idle.

Forced Idle Reminder Tones

The forced idle reminder tone is a high-low "doorphone" tone that sounds under
the following circumstances:
At the extension, to remind the user that the system or the extension is in
the forced idle state
At the programming console or at a PC running SPM, to remind the
system manager that the system (or at least one extension) is in the
forced idle state because of programming activity
Forced idle reminder tones occur every 20 seconds. You can adjust the volume
of these tones with the volume control.
Programming from the Console
This section describes the system programming console and provides the
procedure for entering and exiting system programming from the console.

System Programming Console

The system programming console is an MLX-20L telephone connected to the
system programming jack (the first jack on the first MLX module).
6–12
Managing the System
Procedures
Identify loudspeaker paging extension jack.
Assign trunks to pools.
Specify incoming or outgoing DID or tie
trunk type (AT&T only).
Specify tie trunk direction (AT&T only).
Specify tie trunk E&M signal (AT&T only).
Specify board type (AT&T only).
Specify frame format (AT&T only).
Specify board signaling format (AT&T only).
Specify board suppression format (AT&T
only).
Specify board facility compensation (AT&T
only).