Table of Contents
Advertisement
Changing System Options and Programming Exceptions
These alerts, like most other equipment compatible with the MERLIN LEGEND
system, must be installed, connected to the appropriate ports in the MERLIN
LEGEND system, and programmed.
General instructions for installing external alerts are given in the following list.
Indepth instructions for programming from the CMS Administration screen are
given in the remainder of this section.
1. Line button numbers for the alerts are assigned to line ports on the
MERLIN LEGEND system control unit by the MERLIN LEGEND system
manager.
2. External alerts are mounted on the wall and connected to the line ports
either directly or through building wiring.
3. Each alert is clearly marked and identified as Alert #1, Alert #2, Alert #3,
and Alert #4.
NOTE:
Each external alert has a corresponding line button number.
In CMS, each external alert is represented by the number you have
assigned to it in this step. In step 5, the CMS supervisor has to match
the line button number to its corresponding alert number.
4. From the CMS Administration screen, the CMS supervisor presses [F4]
(Assign Alert) to display the Exception Alerts screen with the following
prompt:
ALERT LINE BUTTON NUMBER : 1:
4:
5. The CMS supervisor matches the assigned line button numbers (1
through 32) to their corresponding alert numbers (1 through 4), and
enters the data. Line button numbers are shown in the CMS Line Button
Planning Form.
NOTE:
During this activity CMS cannot be managing calls. CMS must be in
administration mode during external alert assignment.
2:
3:
Programming Exceptions 4-27
\
Advertisement
Table of Contents
