Sending Documents As An F-Code Based Relay Broadcast Transmission - Kyocera KM-2540 Operation Manual

1.
1/1.
3-46
Changing destinations
13
Memory usage: .0%
JUN-06-2007 16:00
14
Back Close
Add
Change
15
Delete
16
17
Sending Documents as an F-Code Based Relay
Broadcast Transmission
Perform this procedure when you want to act as the initial transmitting
station and send documents, first to an F-Code Relay Box that is
registered in a relay station, and then from that relay station onward to its
final destination.
Restrictions
•
•
Conditions
In the initial transmitting station...As it is necessary to enter, exactly
as it is registered in the relay station's fax, the number (the 4-digit
'subaddress' in this fax) of the box (called the 'F-Code Relay Box' in this
fax) that will receive the documents, as well as its corresponding F-Code
password, be sure to verify that information in advance.
Select one destination to be changed, and then press the [Change]
key.
Enter the new fax number.
You can enter the fax number using the numeric keys, one-touch
keys and the address book. Chain dial keys can be used as well.
Press the [Finish dest. Set] ([Dest. set]) key.
Press the [Close] key.
Once you are finished making all of the modification that you want,
go to the next step.
Press the [OK] key.The message display will return to the same
screen as was displayed in step 2. If you are finished F-Code Relay
Boxes, press the Reset key.
It is necessary that the other fax machine has the same F-Code
Based Relay Broadcast Communication capabilities as your fax
machine. However, depending upon the machine, there is a
possibility that only transmission or only reception under the F-Code
protocol is available, so both the initial transmitting party and the
party acting as the relay station should check in advance whether
the appropriate conditions are met.
The subaddress that is required when this fax is acting as the initial
transmitting station can be up to 20 digits in length, but the number
of digits acceptable in the destination fax may differ. Check with the
relay station and make sure that you register a subaddress that is
within the number of digits that is acceptable to the other party's fax
machine.
Note The fax number of each relay station can be entered with the
numeric keys or using one-touch keys that have been designated
for F-Code Based Communication. If you use the numeric keys it
will be necessary to enter the corresponding subaddress during
the set-up procedure.
The final destinations must be registered in advance under the
corresponding F-Code Relay Box in the relay station fax.
Fax Operation (Advanced)