Modifying Or Deleting F-Code Relay Boxes - Kyocera KM-2540 Operation Manual

Register box
Subaddress relay box
3333.
8888.
0715.
Register box
Subaddress relay box 01.
Password confirmation
Enter password using # key.
_.
( 4 digits)
3-44
If you selected to send a Transmission Report to the initial
transmitting station, go to the next step. If you selected NOT to send
a report, proceed directly to step 14.
12
Enter the fax number of the initial transmitting station.
Note You can use the numeric keys, one-touch keys and
Chain dial keys to enter the fax number.
13
Press the [Finish dest. Set] ([Dest. set]) key.
14
Check the registered information.
Each item can be modified.
15
Press the [OK] key. The message display will return to the same
screen as was displayed in step 4. If you want to continue registering
other F-Code Relay Boxes, repeat steps 4 through 15. Once you are
finished registering F-Code Relay Boxes, press the Reset key.

Modifying or Deleting F-Code Relay Boxes

Perform the following procedure when you want to add or delete final
destinations or change other information registered under any F-Code
Relay Box, as well as when you want to completely delete one of those
boxes.
Note In order to modify the contents of or completely delete an F-
Code Relay Box, it is necessary to enter the corresponding F-
Code password during the procedure.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1
Perform steps 1 through 3 of Registering New F-Code Relay Boxes
on page 3-42.
2
Press the key which displays the subaddress for the F-Code Relay
Box you want to modify or delete.
3
Enter the F-Code password (4-digits) for that F-Code Relay Box.
4
Press the [Confirm] key.
Ba
Fax Operation (Advanced)