Kyocera KM-2540 Operation Manual page 29

Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)
By using an F-Code Box that has been registered in this machine and
designated for F-Code Based Communication to transmit and receive
documents, you can perform Confidential and Bulletin Board
Communications, as well as Relay Broadcast Communications, between
this machine and models from other manufacturers.
In order to perform an F-Code Based Communication, the other party's
fax must have F-Code Based capabilities specific to the communication
you are attempting. Therefore, you should thoroughly discuss in
advance with the party you plan to communicate with the capabilities of
your respective models before attempting to transmit or receive using F-
Code Based Communications.
Refer to Communicating Using F-Codes (F-Code Based
Communication) on page 3-30, for a more detailed information regarding
the F-Code Based Communication capabilities of this fax.
Receiving Documents Even When Paper Has Run Out (Memory
Reception function)
When you cannot print out because paper has run out or a paper jam
occurs, the data for all received documents will be temporarily stored in
memory and will then be printed out automatically once printing is
enabled.
IMPORTANT If, for any reason, power to the fax is disconnected or
lost, data received into memory may be lost. Ask the other party to
retransmit any documents for which data was lost. (Refer to page 4-
2.)
Rotating Received Data to Fit the Available Paper (Rotate
Received Data function)
Even if the orientation of the received documents and of the paper set in
the drawers differs, if their size is the same (11 × 8
will automatically rotate the received data 90° counter-clockwise before
printing it out. No special settings are required to use this function.
Note If paper of the same size is set in different orientations,
depending on the type of communication that is involved, there are
times when rotation of the received data is not possible. For further
information on paper orientation, refer to Paper Size and Priority
Feed Chart (Inch version) on page 8-5, and Paper Size and
Priority Feed Chart (Metric version) on page 8-7.
If the transmitting party's TTI information is set to be printed
outside the border of the transmitted page, received data cannot
be rotated and the received image will be reduced slightly to
enable the appropriate information to be printed out.
" [A4]), this function
1/2
1-15