Modifying Or Deleting Registered Information - Kyocera KM-2540 Operation Manual

Register the dial.
Dial type
One-touch 33600bps
Program
key
Group Chain
Register the dial.
Program Dial(Send) 0006.
Delayed TX/TX type
Delayed TX
Enter using # key.
Start Time 08:00.
Off
On
No Restri-
ction
Register the dial.
Program Dial(Send) 0006.
Enter Destination.
Dest .1 ABC
Delete
ABC GDE
FREE
Address Next
Abbrev.
book destinat.
3-58
4
Press the [Program] key.
Ba
5
If you do NOT want to designate a time of day for the operation to
begin, press the [Off] key under Delayed TX and go directly to step
7.
Ba
6
TX
Use the numeric keys to enter the desired time of day for the
operation to begin.
Send
RX Pol
7
Press the [Send] key or the [RX Polling] key to choose the type of
transmission.
8
Press the [Next] key.
9
Enter the destination fax number.
Pause Space
10
Press the [Finish dest. Set] ([Dest. set]) key.
11
Enter a name for the program and the [Next] key. (Maximum 20
characters)
12
Check the currently registered information and press the key that
corresponds to any item that you want to modify.
13
Press the [OK] key. The message display will return to the same
screen as was displayed in step 3.
If you want to continue registering other program keys, repeat steps
3 through 13. If you are finished registering program keys, press the
Reset key. (P) will be displayed next to the registered speed-dial
key.

Modifying or Deleting Registered Information

Note If you want to change the entered time, use the [ ]
and/or [ ] keys to move the cursor to the desired location.
Note You can enter the fax number using the numeric keys,
abbreviated numbers, one-touch keys or the address book.
Chain dial keys can be used as well.
If you want to enter multiple fax numbers with the numeric
keys, press the [Next destinat.] ([Next dest.]) key after each
fax number.
Note In order to enter characters, refer to Entering Characters
on page 2-13.)
Note If you want to cancel the procedure part way through, press
the Reset key. The touch panel will return to the initial mode
settings.
Fax Operation (Advanced)