Setting The Current Date And Time (Date & Time Setting) - Kyocera KM-2540 Operation Manual

Program Fax Parameter.
Own ID
Enter using # key.
0000. ( 4 digits)
Ready for fax transmission.
Place the original & assign destination.
Dest
Address TX
Abbrev.
book setting
Basic Application
Registering item option screen.
Select item for register.
Fax
Dial Box
Forwarding
Location TX/RX Remote SW
Info. Restrict. dial
Date Remote
& Time Test ID
Basic Application
1-8
6
7
Ba
8
9
Setting the Current Date and Time (Date & Time
setting)
Set the date and the time that will appear in the message display here.
BE SURE that the date and time that you set here are correct since they
will serve as a basis for all communications that use the timer.
IMPORTANT Be sure to periodically check the time that is shown in
the touch panel on the operation panel, and adjust it to match the
current time when necessary.
1
Register Print Report
2
Encryption
key
Register Print Report
Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)
Enter the desired name for your station. (Refer to Entering
Characters on page 2-13.)
Note Your station name can be up to 32 characters in length.
In the Character input screen, press the [End] key. The message
display will return to the same screen as was displayed in step 2.
Registering your station ID
Use the numeric keys to enter the desired station ID (4 digits).
Note If you want to reset the displayed number to 0000,
simply press the Stop/Clear key.
If you want to revise the entered number, press the [ ] or [ ]
cursor key to move the cursor to the number that you want to
change. Then enter the correct number as desired.
Press the [Confirm] key. The message display will return to the same
screen as was displayed in step 2.
If you are finished making settings, press the Reset key to return to
the initial mode.
Note Prior to operation, check the message display to make sure
that the operation panel is in the initial mode for fax operation.
(Refer to What is the Initial Mode? on page 1-9.)
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode screen.
Press the [Register] key. The Register screen will appear.
Press the [Date & Time] key. The currently registered information will
be displayed.