Receiving Documents From An F-Code Based Bulletin Board - Kyocera KM-2540 Operation Manual

Ready for fax transmission.
Place the original & assign destination.
Dest
Address TX
Abbrev.
book setting
Basic Application Register
Option screen
Select item.
Sub.conf. Reserved
TX Polling
box input TX status
Sub.conf. TX result
RX Polling
box output on LCD
Print encr RX result
data box on LCD
Basic Application Register
Scan original to confidential box.
Subaddress confi. box
There are originals saved in the box which is highlighted.
1234.
1111.
Fax Operation (Advanced)
2
Press the [Application] key. The Application screen will appear.
Print Report
3
Press the [Sub. conf. box Input] ([Scan orig. to box]) key.
Print Report
4
Press the key which displays the subaddress for the F-Code
Confidential Box you want to enter documents into.
Ba
If you want simply to add documents to those already in memory, or
you want to delete all of the documents currently in memory and
replace them with new documents, go to the next step.
If you are entering documents for this Confidential Transmission for
the first time, go directly to step 7.
5
1/7.
If you want to add documents, press the [Add] key. If you want to
replace the documents, press the [Overwrite] key.
6
Press the [Confirm] key.
7
Select any related transmission settings that you want to use.
8
Press the Start key. The documents will be scanned into memory.
Receiving Documents from an F-Code Based Bulletin
Board
F-Code Based Bulletin Board Communication involves fax
communication that uses an F-Code Box (in this fax, called an [F-Code
Confidential Box]) that is registered in memory in the transmitting fax
machine and that works like a Bulletin Board server, allowing the same
documents to be made available and transmitted to an unlimited number
of receiving parties.
The transmitting party registers, in advance, an F-Code Box in the their
fax, and enters the documents to be transmitted into that box. Until the
data for those documents is deleted, the documents will remain in that
box for transmission any time they are requested with the correct
subaddress and F-Code password.
Note If you are using duplex (2-sided) documents, press the
[Duplex TX] key. Refer to Sending 2-Sided Documents
(Duplex Transmission) on page 3-3 for setting procedures.
3-39