Turning Tx/Rx Restriction On/Off - Kyocera KM-2540 Operation Manual

Register in TX/RX Restriction list.
Reject FAX numbers 002.
Contents change/del.
.12345678901234567890
Change
contents
Register in TX/RX Restriction list.
Reject FAX numbers 001.
Detail contents
Enter using # key.
(MAX. 20 digits)
.12345678901234567890
System Menu / Counter
System Menu
Copy FAX
Default Default
Machine
Default
Various Settings and Registration
3
Ba
Delete
> Deleting a Reject Fax Number
4
> Modifying information
5
Ba
Tray
6
Delete

Turning TX/RX Restriction ON/OFF

You can select to only allow fax transmission/reception to/from those
facsimiles that are registered in your address book and those registered
as Permit Fax Numbers and Permit IDs. If RX Restriction is set to Reject
List, you can prohibit fax reception from numbers registered as Reject
Fax Numbers, or from other party who does not register its local FAX
Number in its own fax in advance. (Refer to Restricting Communication
To/From Specific Destinations (TX/RX Restriction) on page 6-27.)
1
2
3
4
Job
Language
Accoun
MP Tray
Setting
Register Print
Orig. Size Report
If you want to delete the registered Reject Fax Number, press the
[Delete] key and then go to the next step. If you want to modify the
registered information, press the [Change contents] key and then go
directly to step 5.
Press the [Yes] key. The message display will return to the same
screen as was displayed in step 2. If you are finished deleting Reject
Fax Numbers, press the Reset key.
Press the Stop/Clear key to delete the old number and then enter
the new Reject Fax Number, or use the [ ] and/or [ ] keys to move
the cursor to a desired location and reenter the number as desired.
Pressing the [Delete] key will delete the number directly above the
cursor.
Press the [OK] key. The message display will return to the same
screen as was displayed in step 2. Once you are finished modifying
and/or deleting Reject Fax Numbers, press the Reset key.
Note If you want to cancel the procedure part way through, press
the Reset key. The touch panel will return to the initial mode
settings.
Press the System Menu/Counter key. The System Menu / Counter
screen will appear.
Press the [Fax Default] key.
Press the [ ] cursor key until TX/RX Restriction is highlighted.
Press the [Change #] key.
6-33