Kyocera KM-2540 Operation Manual page 79

n status.
03.
1/1.
Reserved communication status.
Enter Destination.
Dest .1 ABC
Delete
ABC
FREE
Address Next
Abbrev.
book destinat.
Reserved communication status.
Enter Destination.
ABC
Delete
ABC
FREE
Address
Abbrev.
book
Fax Operation (Advanced)
Deleting fax numbers
7
Memory usage: .0%
8
JUN-06-2007 16:00
Back Close
Add
Change
Delete
Adding fax numbers
9
Pause Space
10
Changing fax numbers
11
12
Pause Space
13
14
• If you want to add a fax number(s), press the [Add] key and then
go directly to step 9.
• If you want to change a fax number, press the corresponding
dial key and then proceed directly to step 11.
Press the [Delete] key.
Press the [Yes] key. The message display will return to the same
screen as was displayed in step 6 and you can continue to delete,
add or change other fax numbers. To do so, repeat steps 6 through
13.
If you are finished with this procedure, press the [Close] key and go
to step 14.
Enter the additional fax number(s).
Note You can enter the fax number(s) using the numeric
keys, abbreviated numbers, one-touch keys, group dial keys
and the address book. Chain dial keys can be used as well.
In order to enter multiple destinations with the numeric keys,
press the [Next destinat.] ([Next dest.]) key after you enter
each fax number.
Press the [Finish dest. Set] ([Dest. set]) key. The message display
will return to the same screen as was displayed in step 6 and you
can continue to delete, add or change other fax numbers. To do so,
repeat steps 6 through 13.
If you are finished with this procedure, press the [Close] key and go
to step 14.
Press the [Change] key.
Enter the new destination fax number.
You can enter the fax number(s) using the numeric keys,
abbreviated numbers, one-touch keys and the address book. Chain
dial keys can be used as well.
Press the [Finish dest. Set] ([Dest. set]) key. The message display
will return to the same screen as was displayed in step 6. You can
change, delete or add other fax destination numbers. To do so,
repeat steps 6 through 13. If you are finished with this procedure,
press the [Close] key and go to step 14.
Press the [Confirm] key. The touch panel will return to the initial
mode settings. If the Delayed Communication Report print out
setting is turned ON, a Delayed Communication Report will be
printed out. (Refer to page 6-9.)
3-19