Modifying The Contents Of The Communication - Kyocera KM-2540 Operation Manual

n status.
end (No.party: 001. )
TX No.of pages: 001.
1/2.
Reserved communication status.
Program/Change
Press confirmation key after change setting.
Delayed TX 22:22.
001.
3-18

Modifying the Contents of the Communication

You can modify the information relating to a scheduled communication
that is presently saved in memory. The scheduled time for the
communication to start can be changed, destinations changed, added
and deleted, or the communication can be canceled completely. The
actual procedure and information available for modification is slightly
different depending on the type of communication involved. The example
in the procedure below is for a scheduled Broadcast Transmission that
uses the timer. If you want to modify the information relating other types
of communications, simply refer to this example but follow the flow of the
message display in order to perform the actual procedure.
Note You CANNOT modify a scheduled communication that is
waiting for Automatic Redialing, nor is it possible to modify a
scheduled Polling Communication, a scheduled Broadcast
Transmission, or an F-code Transmission.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1
Perform steps 1 through 3 of Printing Out a Sample Image of Waiting
Documents on page 3-16.
2
Press the [Program/Change] key.
Memory usage: .0%
JUN-06-2007 16:00
Close
Immediate
TX
Program/
Change
Delete
Print
3
If you want to change the scheduled start time, press the [Delayed
TX] key and then go to the next step.
Ba
If you want to modify the destination information, press the [
and then go directly to step 6.
> Changing the scheduled start time
4
Use the numeric keys to enter the desired time for the
communication to begin.
If you want to change the entered time, use the [ ] and/or [ ] keys
to move the cursor to the desired location.
5
Press the [Close] key. The message display will return to the same
screen as was displayed in step 3.
If you also want to modify the destination information, press the [
key. If you do NOT want to modify the information, go directly to step
14.
> Modifying destination information
6
The currently registered information will be displayed.
• If you want to delete a fax number(s), press the corresponding
dial key (or keys) and then go to the next step.
] key
Fax Operation (Advanced)
]