Adapter Retainer; Fan - IBM IntelliStation M Pro Hardware Maintenance Manual

Adapter retainer

Before you begin:
v Read "Safety information" on page 129.
v Read "Installation guidelines" on page 31.
v Review the information in "System reliability considerations" on page 31.
Complete the following steps to remove the adapter retainer:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover (see"Removing the cover" on page 34).
3. Rotate the retainer up, and pull the adapter retainer away from the chassis.
To install the adapter retainer, reverse the previous steps, sliding the two side knobs
on the retainer into the channels provided for them on the chassis and positioning
the retainer so that the plastic tabs are pressed against the inside of the PCI slot
covers.

Fan

Before you begin:
v Read "Safety information" on page 129.
v Read "Installation guidelines" on page 31.
v Review the information in "System reliability considerations" on page 31.
Complete the following steps to remove the fan:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover and the frame-support bracket (see "Removing the cover" on
3. Remove the air baffle (see "Baffle" on page 75).
4. Disconnect the fan cable from the system board.
and power cords. See "Turning off the computer" on page 10.
and power cords.
page 34 and "Removing and installing the support bracket" on page 35).
Release
latch
Retainer slots
FRU information (service only)
77