Table of Contents
Advertisement
6. Connect any required cables to the adapter.
7. Connect the power cables and any previously removed external cables to the
If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation."
Completing the installation
To complete the installation, complete the following steps:
1. Make sure all internal cables are properly routed and are held in place by the
2. Install the top cover.
3. Install the server in a rack. See the Rack Installation Instructions that come with
4. Connect the cables and power cords. See "Connecting the cables" for more
Connecting the cables
You must turn off the server (see "Turning off the server" on page 35) before
connecting any cables to or disconnecting any cables from the server.
See the documentation that comes with optional devices for additional cabling
instructions. It might be easier for you to route cables before you install certain
options.
Cable identifiers are printed on the cables that come with the server and options.
Use these identifiers to connect the cables to the correct connectors.
h. Close the tab; then, push down on the orange adapter retention latch until it
clicks into place, securing the adapter.
server.
wire cable clip in the center of the server.
the server for complete rack installation and removal instructions.
information.
Wire cable clip
(open)
Wire cable clip
(closed)
Chapter 2. Installing options
21
Advertisement
Table of Contents
