Table of Contents
Advertisement
volts
Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
volts (JCS
volts (JCS
Management Module)
Management Module)
Copyright © 2010, Juniper Networks, Inc.
volts -T target
Command supported by Junos OS Release 9.1 and later.
(JCS1200 platform only) Show voltage information for components in the JCS chassis.
This information is useful for viewing current voltage values and voltage threshold settings.
-T target
—Specify the target of the
—Specify a Routing Engine as the command target. Replace
system:blade[x]
the Routing Engine slot number (
—Specify a JCS switch module as the command target. Replace
system:switch[x]
with the switch number (
system:mm[x]
—Specify a JCS management module as the command target. Replace
with the primary management module number (
x
operator (display)
Displaying Voltage Information on page 207
volts (JCS Management Module) on page 231
volts (Routing Engine) on page 232
Table 28 on page 231 lists the output fields for the
in the approximate order in which they appear.
Table 28: volts Output Fields
Field Name
Source
Value
Warning
Reset
Hysteresis
system> volts -T system:mm[1]
Source
Value
Warning
+5v
+4.84
(+4.50,+5.25)
+3.3v
+3.26
(+3.00,+3.47)
Chapter 16: Summary of JCS Management Module Monitoring Commands
volts
command. Valid targets for this command are:
1
through
12
).
or
).
1
2
volts
Field Description
Total voltage available from the voltage source.
Current voltage of the component.
Voltage at which a warning message occurs.
Voltage at which the component will reset.
The amount the voltage must decrease below the Warning threshold
before the warning is cleared.
Reset
(+4.85,+5.15)
(+3.20,+3.40)
or
).
1
2
command. Output fields are listed
Hysteresis
(+0.35,+0.10)
(+0.20,+0.07)
with
x
x
231
Advertisement
Table of Contents
