Figure 14: Example: Shared Interfaces (Gigabit Ethernet) - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

JUNOS 10.4 Protected System Domain Configuration Guide
Overview
PSD5
ut-1/0/0
Configuration
Step-by-Step
Procedure
148
Two Tunnel PICs—one installed on the FPC in slot 1 and the other installed on the FPC
in slot 7
One Gigabit Ethernet PIC installed on the FPC in slot 6
With this example configuration, PSD5 and PSD6 can both transport packets using a
single Gigabit Ethernet PIC owned by RSD3.
As illustrated in Figure 14 on page 148, RSD3 owns physical interface (
owns logical interfaces
ge-6/0/0.0
tunnel interface ut-1/0/0 transports packets between the logical interfaces configured
on the PSD and the physical Gigabit Ethernet interface on RSD3. Similarly, PSD6 owns
logical interface
ge-6/0/0.3
and the physical interface on RSD3.

Figure 14: Example: Shared Interfaces (Gigabit Ethernet)

ut-7/0/0
tunnel to ge-6/0/0.2
First, configure the Routing Engines on the JCS1200 platform using the management
module command-line interface (CLI). Then, configure each T Series router using the
Junos OS CLI.
JCS1200 Configuration on page 148
RSD Configuration on page 149
PSD5 Configuration on page 151
PSD6 Configuration on page 153
JCS1200 Configuration
To configure the parameters required for the Routing Engines in the JCS chassis:
Log in to the JCS management module.
1.
Assign the Routing Engines in slots 5 (primary) and 6 (backup) to RSD3 and PSD1.
2.
Assign the Routing Engine in slot 7 to RSD3 and PSD2.
system> baydata —b 05 —data "V01–JCS01–SD03–PSD01–REP05–REB06–PRDT640"
system> baydata —b 06 —data "V01–JCS01–SD03–PSD01–REP05–REB06–PRDT640"
, , and
ge-6/0/0.1 ge-6/0/0.2
and uses to transport packets between
ut-7/0/0
PSD6
tunnel to ge-6/0/0.3
tunnel to ge-6/0/0.0
tunnel to ge-6/0/0.1
). PSD5
ge-6/0/0
. A cross-connect using
ge-6/0/0.3
RSD3
ge-6/0/0
Copyright © 2010, Juniper Networks, Inc.