Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 196

JUNOS 10.4 Protected System Domain Configuration Guide
Step-by-Step
Procedure
172
}
}
PSD12 Configuration (Router 2)
To configure the route reflector (PSD12):
At the
1. [edit routing-options]
statement to configure the router's AS number.
At the [edit protocols]
2.
the router.
At the
3. [edit protocols bgp]
the routing group.
At the [edit protocols bgp group int]
4.
a. Include the
type internal
b. Include the local-address 10.12.1.3
end of a BGP session. This address is used to accept incoming connections to
the peer and to establish connections to the remote peer.
c. Include the
export nh-self
exported from the routing table into BGP.
d. Include the
neighbor 10.12.1.1
peer (neighbor) of Router 2. You do not need to include neighbor statements for
Router 1 or Router 3.
At the [edit protocols]
5.
on the router.
At the
[edit protocols ospf]
6.
specify the area identifier for this router to use when participating in OSPF routing.
All routers in the area must use the same area identifier to establish adjacencies.
At the
7. [edit protocols ospf area 0.0.0.0]
statement to configure the Gigabit Ethernet interface in the backbone
ge-2/0/2.0
area.
At the [edit protocols ospf area 0.0.0.0]
8.
statement to configure the Gigabit Ethernet interface in the backbone
ge-2/0/3.0
area.
At the [edit protocols ospf area 0.0.0.0]
9.
statement to configure the Gigabit Ethernet interface in the backbone
ge-2/0/1.0
area.
At the [edit protocols ospf area 0.0.0.0 interface ge-2/0/1.0]
10.
the
bfd-liveness-detection
At the
[edit protocols ospf area 0.0.0.0 interface ge-2/0/1.0 bfd-liveness-detection]
11.
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level:
statement to configure an internal BGP group.
statement to specify the address of the local
statement to apply the
statement to specify the route reflector (RR) as
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
statement to specify bidirectional failure detection timers.
minimum-interval 333
autonomous-system 2
bgp statement to enable BGP on
statement to define
group int
policy to routes being
nh-self
ospf statement to enable OSPF
statement to
area 0.0.0.0
interface
interface
interface
hierarchy level, include
statement to specify 333
Copyright © 2010, Juniper Networks, Inc.