Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 165

Results
Copyright © 2010, Juniper Networks, Inc.
At the
3. [edit interfaces ut-1/0/0 unit n]
so-6/0/0.logical-unit-number
together. Use the following
For unit 0, the value is
For unit 1, the value is
For unit 2, the value is
At the [edit interfaces so-6/0/0]
4.
statement to match the configuration on the RSD, and the
frame-relay
statement to identify the physical interface as the shared interface.
shared-interface
At the [edit interfaces so-6/0/0]
5.
statements to configure logical interfaces.
At the [
edit interfaces so-6/0/0 unit n
6.
statements:
peer-interface peer-interface
together. Use the following
For unit 0 , the value is
For , the value is
unit 1
For unit 2 , the value is
—Configure the DLCI for the point-to-point Frame Relay connection. Use
dlci dlci
the following dlci values:
For , the value is
unit 0
For unit 1 , the value is
For , the value is
unit 2
family inet address address
on the logical SONET interface. Use the following
For , the value is
unit 0
For , the value is
unit 1
For , the value is
unit 2
Display the results of the configuration:
interfaces {
ut-1/0/0 {
unit 0 {
peer-interface so-6/0/0.0;
}
unit 1 {
peer-interface so-6/0/0.1;
hierarchy level, include the
statement to bind the tunnel and SONET interfaces
logical-unit-number values:
.
0
1 .
.
2
hierarchy level, include the
hierarchy level, include
] hierarchy level, include the following
—Bind the SONET and tunnel interface interfaces
values:
peer-interface
ut-1/0/0.0 .
.
ut-1/0/0.1
ut-1/0/0.2 .
.
16
17 .
.
18
—Configure the IP version 4 (IPv4) suite protocol family
.
10.70.0.1/30
.
17.17.17.1/30
.
18.18.18.1/30
Chapter 14: Configuration Examples
peer-interface
encapsulation
unit 0 , unit 1 , and unit 2
values:
address
141