Table of Contents
Advertisement
temps
Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
temps (Routing
temps (Routing
Engine)
Engine)
Copyright © 2010, Juniper Networks, Inc.
temps -T target
Command supported by Junos OS Release 9.1 and later.
(JCS1200 platform only) Show temperature information (in degrees Fahrenheit) for
components in the JCS chassis. This information is useful for viewing current temperature
values and temperature threshold settings.
-T target
—Specify the target of the
—Specify a Routing Engine as the command target. Replace
system:blade[x]
the Routing Engine slot number (
—Specify a JCS switch module as the command target. Replace
system:switch[x]
with the switch number (
—Specify a JCS management module as the command target. Replace
system:mm[x]
with the primary management module number (
x
operator (display)
Displaying Temperature Information on page 206
temps (Routing Engine) on page 229
temps (JCS Management Module) on page 230
Table 27 on page 229 lists the output fields for the
listed in the approximate order in which they appear.
Table 27: temps Output Fields
Field Name
Value
Warning
Reset
Hysteresis
system> temps -T system:blade[3]
Component
Value
CPU1
38.00
CPU2
35.00
Chapter 16: Summary of JCS Management Module Monitoring Commands
temps
command. Valid targets for this command are:
1
through
12
).
or
).
1
2
temps
Field Description
Current temperature (in degrees Fahrenheit) of the component.
Temperature at which a warning message occurs.
Temperature at which the component will reset.
The amount the temperature must decrease below the Warning
threshold before the warning is cleared.
Warning
Reset
Hysteresis
85.00
95.00
(7.00)
85.00
95.00
(7.00)
or
).
1
2
command. Output fields are
with
x
x
229
Advertisement
Table of Contents
