Configuring The Time Zone; Configuring The System Name And Contact Information; Configuring Snmp Traps - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

Protected system domain configuration
Table of Contents

Advertisement

Configuring the Time Zone

Configuring the System Name and Contact Information

Configuring SNMP Traps

Copyright © 2010, Juniper Networks, Inc.
In this example, the IP address of the NTP server is
module clock is updated by the NTP server every
To configure the time zone on the JCS management module:
Log in to the JCS management module.
1.
Use the
command to set JCS management module 1 (
env
2.
target. For example:
system> env —T mm[1]
Use the
command to configure the time zone. For example:
3.
clock
system:mm[1]> clock —g —8 —dst uc
In this example, the clock is configured for 8 hours earlier than UTC (GMT) (
and daylight saving time for the USA and Canada (
JCS management module configuration should include the system name of the JCS 1200
platform (to identify the JCS1200 platform on the network), the physical location of the
JCS1200 platform, and a contact person for the JCS1200 platform. Typically, the contact
is someone who has Supervisor access to the JCS1200 platform.
To configure the system name, location, and contact information for the JCS management
module:
Log in to the JCS management module.
1.
Use the
env
command to set JCS management module 1 (
2.
target. For example:
system> env —T mm[1]
Use the
command to configure the system name, location, and contact
3.
config
information for the JCS. For example:
system:mm[1]> config -name system5 -contact "George Chang email=chang@corp.net
phone=x2368" —loc "Software Lab, Main Campus, Building 12"
In this example, the system name is
network, appears in monitoring command output, and so on. The contact information
is for
George Chang
and the location is
The Simple Network Management Protocol (SNMP) enables the monitoring of network
devices from a central location. This section describes how to configure SNMP traps on
the JCS management module.
Chapter 6: Configuring Basic System Parameters
, the JCS management
172.17.28.5
minutes, and NTP is enabled.
60
mm[1]
) is set.
-dst uc
mm[1]
. This name identifies the JCS on the
system5
Software Lab
.
) as the configuration
-g -8
),
) as the configuration
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junos os 10.4

Table of Contents