Table of Contents
Advertisement
CHAPTER 10
Configuring Basic System Properties on a
New PSD
Configuring a PSD with a Single Routing Engine
Copyright © 2010, Juniper Networks, Inc.
Configuring a PSD with a Single Routing Engine on page 87
Configuring a PSD with Redundant Routing Engines on page 89
To initially configure a PSD with a single Routing Engine:
Connect to the console port on the Routing Engine that is assigned to the PSD you
1.
want to configure.
At the
login
prompt on the console, log in with the username
2.
Initially, the
user account requires no password. You can see that you are the
root
user, because the prompt on the routing platform shows the username
Start the Junos OS command-line interface (CLI):
3.
root@% cli
root@>
Enter Junos OS configuration mode:
4.
cli> configure
[edit]
root#
Configure the name of the routing platform (the routing platform hostname). We do
5.
not recommend spaces in the routing platform name. However, if the name does
include spaces, enclose the entire name in quotation marks (" ").
[edit]
root# set system host-name host-name
Configure the routing platform's domain name:
6.
[edit]
root# set system domain-name domain-name
Configure the IP addresses and prefix lengths for one or both of the router management
7.
Ethernet interfaces (
fxp0
[edit]
and
fxp1
) on each Routing Engine.
root
.
root
.
root@%
87
Advertisement
Table of Contents
