Table of Contents
Advertisement
ifconfig (JCS Management Module)
Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Summary of JCS Management Module Configuration Commands
ifconfig -T system:mm[x] (-eth0 | -eth1) <enabled | disabled> <-c static>
<-g gateway-address> <-i static-ip-address> <-s subnet-mask>
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Configure or display the JCS management module
Ethernet interface.
—Specify a JCS management module as the command target. Replace
-T system:mm[x]
with the primary management module number (
x
is the only valid target available for this command.
—Specify Ethernet channel 0 or Ethernet channel 1.
-eth0 | -eth1
—(Optional) Enable or disable the Ethernet interface on the JCS
enabled | disabled
management module.
—(Optional) Specify static IP configuration.
-c static
-g gateway-address
—(Optional) Gateway IP address of the Ethernet interface on the JCS
management module.
—(Optional) Static IP address of the Ethernet interface on the JCS
-i static-ip-address
management module.
—(Optional) Subnet mask of the Ethernet interface on the JCS
-s subnet-mask
management module.
operator (display)
supervisor (display or configure)
Configuring the JCS Management Module Ethernet Interface on page 40
ifconfig (Display) on page 66
ifconfig (Configure) on page 66
Table 9 on page 65 lists the output fields for the
listed in the approximate order in which they appear.
Table 9: ifconfig Output Fields
Field Name
-i
-g
or
1
ifconfig
Field Description
IP address of the Ethernet interface on the JCS management
module.
Gateway IP address of the Ethernet interface on the JCS
management module.
). The JCS management module
2
command. Output fields are
65
Advertisement
Table of Contents
