Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 209

Step-by-Step
Procedure
Results
Copyright © 2010, Juniper Networks, Inc.
l2vpn {
encapsulation-type frame-relay;
site 2 {
site-identifier 2;
interface so-4/0/3.2 {
remote-site-id 1;
}
}
}
}
}
}
PSD2 Configuration
The configuration for PSD2 is much the same as the configuration that was running on
the T640 router in the original VPN network topology before the consolidation of two
routers into a single platform.
The key difference is the management configuration. To configure the unique parameters
for PSD2:
Configure the following statements at the
1.
a. Include the host-name customer-b
master Routing Engine (
b. Include the
backup-router 192.168.71.254
The backup router should be directly connected to the local routing platform by
way of the management interface.
c. Include the
address 192.168.66.240/21
hierarchy level to configure the
0 family inet]
Configure the backup Routing Engine parameters by including the following
2.
statements at the
[edit system re1]
a. Include the host-name customer-b1
the backup Routing Engine (
b. Include the
backup-router 192.168.71.254
The backup router should be directly connected to the local routing platform by
way of the management interface.
c. Include the
address 192.168.66.242/21
hierarchy level to configure the
0 family inet]
Display the results of the configuration:
re0 {
system {
host-name customer-b;
backup-router 192.168.71.254 destination [ 172.16.0.0/12 192.168.0.0/16
207.17.136.192/32 10.9.0.0/16 10.10.0.0/16 10.13.10.0/23 10.84.0.0/16 10.5.0.0/16
Chapter 14: Configuration Examples
[edit system re0]
statement to configure the hostname for the
) on PSD2.
re0
statement to configure a backup router.
statement at the
management interface.
fxp0
hierarchy level:
statement to configure the hostname for
) on PSD2.
re1
statement to configure a backup router.
statement at the
management interface.
fxp0
hierarchy level:
[edit interfaces fxp0 unit
[edit interfaces fxp0 unit
185