Table of Contents
Advertisement
JUNOS 10.4 Protected System Domain Configuration Guide
Table 4: Target Paths for JCS Modules
Item
JCS1200 platform
JCS management module
Routing Engine (blade server)
JCS switch module
JCS Switch Module Script
26
Use the
command to change the command target. For example:
env
The following command changes the command target from
management module 1 (
system> env -T mm[1]
OK
system:mm[1]>
The command prompt changes to
Unless otherwise directed, all commands you enter apply to the target shown by
the prompt.
To return the command target to the top level of the hierarchy, type the following:
system:mm[1]: env -T system
OK
system>
Use the
option to temporarily override the active command target for individual
-T
commands. For example, to include the following command option to redirect a
command to the JCS management module in slot (bay 1), type:
-T system:mm[1]
Table 4 on page 26 lists command targets you typically use to configure and monitor the
JCS1200 platform.
Target Path
system
system:mm[x]
system:blade[x]
system:switch[x]
NOTE: Additional target paths are available in the JCS management module
CLI.
The JCS switch module includes a menu-based interface that runs on the JCS1200
platform. However, instead of using menus to configure the switch, Juniper Networks
provides a script you can use for configuring the switch.
mm[1]
):
system:mm[1]
to indicate the command target.
Description
–
is the management module number (
x
or
)
2
is the blade slot number (
x
is the switch number (
x
Copyright © 2010, Juniper Networks, Inc.
to JCS
system
1
through
)
1
12
or
)
1
2
Advertisement
Table of Contents
