Table of Contents
Advertisement
JUNOS 10.4 Protected System Domain Configuration Guide
Related
Documentation
Clearing the Event Log
Purpose
Action
Related
Documentation
Displaying the Event Log
Purpose
202
Rev:
Blade sys. mgmt. proc.
Build ID:
Rev:
Local Control
KVM:
Media Tray:
SCOD: Unknown
Power On Time: 5 days 20 hours 35 min 12 secs
Number of Boots: 3
JCS1200 Platform Hardware Components on page 21
info on page 219
The event log stores events that occur on the JCS1200 platform. This includes user login
activity, configuration changes, error conditions, and so on. Periodically, you may wish to
clear the event log to remove exiting events.
Clear the event log using the JCS management module CLI
The following sample output appears when the event log for the JCS management
module is cleared:
system> clearlog —T system:mm[1]
OK
The following sample output shows information that is returned if the
is run after the event log has been cleared.
system:mm[1]> displaylog -f
1 I SERVPROC 01/28/08 19:50:15
(There are no more entries in the event log.)
clearlog on page 211
displaylog on page 212
The JCS software generates event log messages to record events that occur on the
JCS1200 platform, including the following:
Routine operations, such as configuration changes and user login activities.
Failure and error conditions.
Emergency and critical conditions, such as power-off due to excessive temperature.
You can display the event log to monitor JCS1200 platform operations and to diagnose
and troubleshoot problems.
1.04
BCBT42B
1.11
Yes
Yes
System log cleared.
clearlog
command.
command
displaylog
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
