Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 167

Results
Verification
Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
peer-interface ut-7/0/0.0
—Configure the DLCI for the point-to-point Frame Relay connection.
dlci 100
family inet address 10.10.10.1/24
family.
Display the results of the configuration:
interfaces {
ut-7/0/0 {
unit 0 {
peer-interface so-6/0/0.3;
}
}
so-6/0/0 {
encapsulation frame-relay;
shared-interface;
unit 3 {
peer-interface ut-7/0/0.0;
dlci 100;
family inet {
address 10.10.10.1/24;
}
}
}
Verifying Shared Interfaces on RSD3 on page 143
Verifying Shared Interfaces on PSD5 on page 145
Verifying Shared Interfaces on PSD6 on page 146
Verifying Shared Interfaces on RSD3
From RSD3, display the status of shared interfaces.
Issue the
show interfaces so-6/0/0
user@rsd3> show interfaces so-6/0/0
Physical interface: so-6/0/0, Enabled, Physical link is Up
Interface index: 128, SNMP ifIndex: 109
Link-level type: Frame-Relay, MTU: 4474, Clocking: Internal, SONET mode,
Speed: OC192, Loopback: None, FCS: 16, Payload scrambler: Enabled
Device flags : Present Running Down
Interface flags: Hardware-Down Point-To-Point SNMP-Traps Internal: 0x4000
Shared-interface : Owner
Link flags : No-Keepalives DTE
ANSI LMI settings: n391dte 6, n392dte 3, n393dte 4, t391dte 10 seconds
LMI: Input: 0 (never), Output: 0 (never)
DTE statistics:
Enquiries sent
Full enquiries sent
Enquiry responses received
Full enquiry responses received
DCE statistics:
Chapter 14: Configuration Examples
—Bind the SONET and tunnel interfaces together.
—Configure the IP version 4 (IPv4) suite protocol
command:
: 0
: 0
: 0
: 0
143