reset
Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
reset (Switch)
reset (Switch)
Copyright © 2010, Juniper Networks, Inc.
reset -T target
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Reset a specified Routing Engine (blade), JCS switch
module, or JCS management module.
-T target
—Specify the target of the
—Specify a Routing Engine as the command target. Replace
system:blade[x]
the Routing Engine slot number (
—Specify a JCS switch module as the command target. Replace
system:switch[x]
with the switch number (
system:mm[x]
—Specify a JCS management module as the command target. Replace
with the primary management module number (
x
supervisor
power on page 224
reset (Switch) on page 227
When you enter this command, you are provided feedback on the status of your request.
system> reset –T system:switch[2]
OK
Chapter 16: Summary of JCS Management Module Monitoring Commands
reset
command. Valid targets for this command are:
1
through
12
).
or
).
1
2
or
).
1
2
with
x
x
227