Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
a. Include the
type internal
b. Include the
local-address 10.12.1.4
end of a BGP session. This address is used to accept incoming connections to
the peer and to establish connections to the remote peer.
c. Include the
export nh-self
exported from the routing table into BGP.
d. Include the
neighbor 10.12.1.1
peer (neighbor) of Router 3. You do not need to include neighbor statements for
Router 1 or Router 2.
At the
[edit protocols]
5.
on the router.
At the
6.
[edit protocols ospf]
specify the area identifier for this router to use when participating in OSPF routing.
All routers in the area must use the same area identifier to establish adjacencies.
At the
[edit protocols ospf area 0.0.0.0]
7.
statement to configure the Gigabit Ethernet interface in the backbone
ge-0/2/3.0
area.
At the
[edit protocols ospf area 0.0.0.0]
8.
statement to configure the Gigabit Ethernet interface in the backbone
ge-0/1/7.0
area.
At the
[edit protocols ospf area 0.0.0.0]
9.
ge-0/1/0.0
statement to configure the Gigabit Ethernet interface in the backbone
area.
At the
[edit protocols ospf area 0.0.0.0 interface ge-0/1/0.0]
10.
the
bfd-liveness-detection
At the
[edit protocols ospf area 0.0.0.0 interface ge-0/1/0.0 bfd-liveness-detection]
11.
hierarchy level, include the
milliseconds as the minimum interval at which the local router transmits a hello
packet and then expects to receive a reply from its BFD neighbor.
At the
[edit policy-options]
12.
statement to define the
A routing policy contains one or more terms. The
includes three terms (
exported from the routing table into BGP.
At the
13.
[edit policy-options nh-self]
define the first term for the
At the
[edit policy-options nh-self term a]
14.
statements to specify that any static route with destination prefix
rejected:
from {
protocol static;
statement to configure an internal BGP group.
statement to specify the address of the local
statement to apply the
statement to specify the route reflector (RR) as
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
statement to specify bidirectional failure detection timers.
minimum-interval 333
hierarchy level, include the
nh-self
policy.
,
and
). This policy is applied to routes
term a
term b,
term c
hierarchy level, include the
policy.
nh-self
hierarchy level, include the following
Chapter 14: Configuration Examples
policy to routes being
nh-self
statement to enable OSPF
ospf
statement to
area 0.0.0.0
interface
interface
interface
hierarchy level, include
statement to specify 333
policy-statement nh-self
policy you are defining
nh-self
statement to
term a
0.0.0.0/0
is
175
Advertisement
Table of Contents
