Read - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

JUNOS 10.4 Protected System Domain Configuration Guide

read

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
read read
226
read -config chassis -T system:mm[x]
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Restore the JCS management module configuration
from an image previously saved to the JCS chassis with the
command is useful for restoring a backup copy of the JCS management module
configuration.
—Specify the location within the chassis from which the configuration is
-config chassis
restored.
-T system:mm[x] —Specify the management module as the target of the command (the
configuration to be saved). Replace
-config file (-i, -l, -p) —Specify the location outside the chassis and the name of the file
from which the configuration is restored.
—Specify the IP address of the TFTP server where the configuration file is located.
-i
-l —Specify the file name of the configuration file to read(the default filename is asm.cfg).
—Specify the quote-delimited passphrase that is required when saving to a file with
-p
encryption enabled (passphrases have a maximum of 1600 chars).
supervisor
write on page 233
read on page 226
When you enter this command, you are provided feedback on the status of your request.
system> read —config chassis –T system:mm[1]
OK
Configuration restore from the chassis was successful.
Restart the MM for the new settings to take effect.
When you enter this command, the amm.cfg file will be loaded from the TFTP server
that corresponds with the IP address you entered.
system> read -T mm[1] -config file -i 172.17.59.183 -l amm.cfg
write
with a value of or .
x 1 2
Copyright © 2010, Juniper Networks, Inc.
command. This