Write - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

write

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
write write
Copyright © 2010, Juniper Networks, Inc.
write -config chassis -T system:mm[x]
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Save the management module configuration to the
chassis of the JCS1200 platform (in the midplane NVRAM). This command is useful for
creating a backup copy of the JCS management module configuration.
-config chassis —Specify the location within the chassis where the configuration is saved.
—Specify the JCS management module as the target of the command
-T system:mm[x]
(the configuration to be saved). Replace
—Specify the name of the configuration file and location where it is
-config file (-i, -l, -p)
saved outside the chassis.
-i —Specify the IP address of TFTP server to save the configuration file to.
—Specify an optional filename to save the configuration file as (the default filename
-l
is asm.cfg).
—Specify the quote-delimited passphrase that is required when saving to a file with
-p
encryption enabled (passphrases have a maximum of 1600 chars).
supervisor
read on page 226
write on page 233
When you enter this command, you are provided feedback on the status of your request.
system> write —config chassis –T system:mm[1]
OK
Configuration settings were successfully saved to the chassis.
When you enter this command, the configuration file will be named "amm.cfg" and saved
on the TFTP server at 172.17.59.183.
system> write -T mm[1] -config file -i 172.17.59.183 -l amm.cfg
Chapter 16: Summary of JCS Management Module Monitoring Commands
x with a value of 1 or 2 .
233