Table of Contents
Advertisement
APPENDIX A
Troubleshooting
Troubleshooting a Routing Engine on the JCS1200 Platform
Problem
Solution
Copyright © 2010, Juniper Networks, Inc.
Troubleshooting a Routing Engine on the JCS1200 Platform on page 253
Restarting a Routing Engine on the JCS1200 Platform on page 254
You cannot run the Junos OS on a Routing Engine on the JCS1200 platform and you
cannot reload the software using the Junos OS CLI.
Manually load the Junos OS on the Routing Engine in the JCS chassis using the media
tray.
NOTE: This procedure requires that you issue commands on the JCS
management module CLI and to interactively respond to prompts from the
Junos OS through a console port session on the Routing Engine.
CAUTION: When you manually reload the Junos OS, the hardware disk and
CompactFlash card are erased.
To manually load the Junos OS on a specific Routing Engine in the JCS chassis:
Obtain the Junos OS package from the Juniper Networks support Web site and transfer
1.
the software onto a USB device. For more information, contact your Juniper Networks
support representative.
Insert the USB device with the Junos OS into either USB port on the media tray on the
2.
JCS chassis.
To select the Routing Engine, either press the CD button on the Routing Engine or
3.
issue the following command using the JCS management module CLI. In this example,
the Routing Engine to be reloaded is in slot 1 on the JCS chassis.
system> mt -b 1
253
Advertisement
Table of Contents
