Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 206

JUNOS 10.4 Protected System Domain Configuration Guide
Results
Step-by-Step
Procedure
Results
182
Display the results of the configuration:
chassis {
system-domains {
root-domain-id 1;
protected-system-domains {
psd1 {
fpcs 4;
control-system-id 1;
control-slot-numbers 4;
}
psd2 {
fpcs 5;
control-system-id 1;
control-slot-numbers [5 6];
}
}
}
}
PSD1 Configuration
The configuration for PSD1 is much the same as the configuration that was running on
the T640 router in the original VPN network topology before the consolidation of two
routers into a single platform.
The key difference is the management configuration. To configure the unique parameters
for PSD1:
Configure the following statements at the
1.
a. Include the host-name customer-a
PSD1.
b. Include the
backup-router 192.168.71.254
The backup router should be directly connected to the local routing platform by
way of the management interface.
c. Include the
address 192.168.66.240/21
unit 0 family inet]
Display the results of the configuration:
re0 {
system {
host-name customer-a;
backup-router 192.168.71.254 destination [ 172.16.0.0/12 192.168.0.0/16
207.17.136.192/32 10.9.0.0/16 10.10.0.0/16 10.13.10.0/23 10.84.0.0/16 10.5.0.0/16
10.6.128.0/17 192.168.102.0/23 207.17.136.0/24 10.209.0.0/16 10.227.0.0/16
10.150.0.0/16 10.157.64.0/19 10.204.0.0/16 ];
}
interfaces {
fxp0 {
unit 0 {
family inet {
[edit groups re0 system]
statement to configure the hostname for
statement to configure a backup router.
statement at the
hierarchy level to configure the management interface.
hierarchy level:
[edit interfaces fxp0
Copyright © 2010, Juniper Networks, Inc.