Drive Cable Assembly - Compaq 100eu - All-in-One PC Maintenance & Service Manual

Drive Cable Assembly

Description
Hard drive/optical drive cable assembly
A single drive cable provides data and power to both the hard drive and the optical drive. The cable
connects both drives to the system board, as well as connects to a power connector on the system
board.
1. Prepare the computer for disassembly (see
on page
2. Remove the stand (see
3. Remove the hinge cover (see
4. Remove the memory/optical drive cover (see
5. Remove the rear cover (see
6. Remove the rear metal cover (see
7. Disconnect the cable from the following connectors:
● (1): Optical drive
●
(2): Hard drive
●
(3): 2 system board SATA connectors (hard drive = SATA0, optical drive = SATA1)
●
(4): system board power connector (SATA_PWR)
8. Remove the cable from the clip on the base of the computer (5), and then lift the cable assembly
from the computer.
Figure 8-17
To replace the drive cable assembly, reverse the removal procedures.
106).
Stand on page
Hinge Cover on page
Rear Cover on page
Removing the drive cable
Preparing to disassemble the computer
111).
112).
Memory/Optical Drive Cover on page
113).
Rear Metal Cover on page
Spare part number
623375-001
107).
118).
Drive Cable Assembly
123