Power Switch/LED Assembly
Description
Power switch/LED assembly
The power switch/LED assembly is secured with a tab and hooks. The cable is held in place with
chassis clips located under the optical drive.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Lay the computer on its side with the front facing toward you.
4.
Remove the front bezel
5.
Remove the optical drive
6.
Disconnect the braided cables from the black system board connector labeled J18.
7.
Remove the power switch cable from the clips located in the optical drive bay on the inside of
the chassis.
64
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page
45).
(Removing an Optical Drive on page
44).
59).
Spare part number
622204-001
43).