Installing A 3.5-Inch Drive Into A 5.25-Inch Drive Bay - Compaq ProSignia 200 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-22 Installing Hardware Options
Either a third-height or a half-height drive may be installed into a
half-height bay.
When installing optional drives, you must install one guide screw to line the
drive up correctly in the drive cage.
Install the guide screw in the middle hole on 3.5-inch drives (drive
bays 2, 3, and 4).
Install the guide screw in the front hole on 5.25-inch drives.
Compaq has provided extra guide screws, installed in the front of the server
chassis, under the front bezel.
Installing a 3.5-Inch Drive
into a 5.25-Inch Drive Bay
To install a 3.5-inch drive into a 5.25-inch drive bay, complete the following
steps:
1. Shut down all programs and the operating system.
2. Turn off the server, disconnect the power cord from the electrical
outlet, and remove the side access panel and front bezel.
Writer: Compaq Computer Corporation Project: Installing Hardware Options Comments:
File Name: E-ch3.doc Last Saved On: 4/14/97 11:21 AM