Removing a Hard Drive
NOTE:
Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers,
and any software applications that were preinstalled on the computer. If you do not have this CD set,
select Start > HP Backup and Recovery and create it now.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the optical drive
5.
Remove the two screws that secure the hard drive to the chassis.
Figure 7-12
90
Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Access Panel on page
(Front Bezel on page
(Removing an Optical Drive on page
Removing the Hard Drive Retainer Screws
(Preparation for Disassembly on page
78).
79).
77).
87).