Power Switch Cable Assembly - Compaq AP500 Maintenance And Service Manual
Professional workstation
Hide thumbs
Also See for AP500:
- Reference manual (173 pages) ,
- Supplementary manual (21 pages) ,
- Technical manual (13 pages)
Table of Contents
Advertisement
3-54
Removal and Replacement Procedures
Power Switch Cable Assembly
The power switch cable assembly can be replaced without removing the power supply. To
remove the power switch cable assembly:
1.
Perform the service preparations shown on page 3-2.
2.
Remove the following components:
Side access panel
Front bezel
CD-ROM drive or DVD-ROM drive (if installed)
3.
Disconnect the power switch cable from the system board.
4.
Remove the screws that keep the power switch cable assembly in place.
5.
Remove the crown from the power switch cable assembly.
6.
Gently slide the cable through the CD-ROM drive bay opening.
7.
Remove the power switch cable assembly from the chassis.
Figure 3-50. Removing the power switch cable assembly
To replace the power switch cable assembly, reverse the above procedure.
Advertisement
Table of Contents
