11.
Replace the screw that secures the slot cover retainer in place.
Figure 7-21
12.
Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
13.
Replace the optical drive.
14.
Replace the front bezel and access panel.
15.
Reconnect the power cord and any external devices, then turn on the computer.
16.
Reconfigure the computer, if necessary. Refer to the F10 Setup Utility chapter for instructions on
using Computer Setup.
Front USB Panel
Description
Front USB panel
The front panel includes two USB connectors and two audio connectors. The panel is housed in a
bracket, and the assembly secured to the front of the computer with one screw.
The board can be removed from the bracket by removing two screws.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
Remove the optical drive
96
Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Replacing the Slot Cover Retainer Screw
(Front Bezel on page
(Removing an Optical Drive on page
(Preparation for Disassembly on page
(Access Panel on page
79).
Spare part number
622194-001
77).
78).
87).