Table of Contents
Advertisement
Speakers
Description
Speakers
There are two separate speakers mounted to the bottom of the computer with four screws, two for
each speaker. The speaker cables are secured by clips and tape on the base of the computer.
1.
Prepare the computer for disassembly (see
on page
2.
Remove the stand (see
3.
Remove the hinge cover (see
4.
Remove the memory/optical drive cover (see
5.
Remove the rear cover (see
6.
Remove the rear metal cover (see
7.
Disconnect the cable from the system board connector labeled SPK_CON (1).
8.
Remove the four black Phillips PM 3.0x11.0 screws (2) that secure the speakers to the
computer.
9.
Remove the speaker cables from the metal clips built into the computer (3).
Figure 8-18
10.
Remove the tape that secures the speaker wires to the computer, and then lift the speaker
assembly from the computer.
To replace the speakers, reverse the removal procedures.
124
Chapter 8 Removal and Replacement Procedures All-in One (AIO) Chassis
106).
Stand on page
Hinge Cover on page
Rear Cover on page
Removing the speakers
Preparing to disassemble the computer
111).
112).
Memory/Optical Drive Cover on page
113).
Rear Metal Cover on page
Spare part number
625119-001
107).
118).
Advertisement
Table of Contents
