Installing A 3.5-Inch Hard Drive Into A 3.5-Inch Drive Bay - Compaq Deskpro 2000 Series Reference Manual

Installing the Hard Drive and Securing It with Two Retaining Screw

Installing a 3.5-inch Hard Drive into a 3.5-inch Drive Bay

-24
6 Upgrading the Minitower Computer
7. Secure the hard drive with two retaining screws.
8. Skip the next section and go to "Completing the
Installation."
If you are installing a 3.5-inch hard drive into drive bay
location 1 , a bracket will not be needed.
To install a 3.5-inch hard drive into a 3.5-inch drive bay
(location 1 ), complete the following instructions:
1. Complete instructions 1 through 2 in the "Installation
Procedures" section.
2. Insert one standard (guide) screw on the side of the hard
drive that is opposite the switch.
3. Install the hard drive assembly into the 3.5-inch bay using
the guide screw to position the assembly.
4. Install the drive bezel and secure the hard drive with two
retaining screws.
5. Complete the instructions in the "Completing the
Installation" section.