Power Button Board - Compaq 100eu - All-in-One PC Maintenance & Service Manual

Power Button Board

Description
Power button board
The power button board is located on the top/left of the computer (viewed from the back). The board
is held in place using two tabs.
1. Prepare the computer for disassembly (see
on page
2. Remove the stand (see
3. Remove the hinge cover (see
4. Remove the memory/optical drive cover (see
5. Remove the outer rear cover (see
6. Pull the two tabs that hold the board in place away from the board (1), and then lift the board
from the slot (2).
7. Disconnect the cable from the board (3).
NOTE:
on the wires.
Figure 8-10
To install the power button board, reverse the removal procedures.
116 Chapter 8 Removal and Replacement Procedures All-in One (AIO) Chassis
106).
Stand on page
Hinge Cover on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Removing the power button board
Preparing to disassemble the computer
111).
112).
Memory/Optical Drive Cover on page
Rear Cover on page 113).
Spare part number
624580-001
107).