Display Board
Description
Display board
The display board is located on the bottom/left of the computer (viewed from the back). The board is
held in place with two screws.
1.
Prepare the computer for disassembly (see
on page
2.
Remove the stand (see
3.
Remove the hinge cover (see
4.
Remove the memory/optical drive cover (see
5.
Remove the outer rear cover (see
6.
Remove the two silver PM 2.5x5.0 screws that secure the board to the computer (1).
7.
Lift the board from the computer as far as the cable will allow (2).
8.
Disconnect the cable from the board (3).
NOTE:
on the wires.
Figure 8-11
To install the display board, reverse the removal procedures.
106).
Stand on page
Hinge Cover on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Removing the display board
Preparing to disassemble the computer
111).
112).
Memory/Optical Drive Cover on page
Rear Cover on page
113).
Spare part number
624579-001
107).
Display Board
117