Access Panel
Description
Access panel
The access panel is held in place with two screws.
1.
Prepare the computer for disassembly
CAUTION:
and that the power cord is disconnected from the electrical outlet.
2.
Remove the two screws (1) that secure the access panel to the computer chassis.
3.
Slide the access panel back about 1.3 cm (1/2 inch) (2), and then lift it off the unit.
NOTE:
Figure 7-1
To install the access panel, reverse the removal procedure.
78
Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Before removing the computer access panel, ensure that the computer is turned off
You may want to lay the computer on its side to install internal parts.
Removing the access panel
(Preparation for Disassembly on page
Spare part number
623386-001
77).